Smart Actuators support dynamic fade times and can only be used with the Lighting Controller. Use device with Standard Actuator(s) or Smart Actuator(s) Save into the Miniserver, in order to pair the Extension.Īfterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Extension into the program. This can only be used if there is only one Extension of the same type. Specifies the serial number of the device.įor Extensions: Enter 'Auto' to automatically pair an extension with unknown serial number. When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. To solve this problem, split consumers of higher power over longer distances to several supply lines, or use a supply line with a higher cross-section, or a power supply close to the consumers.įor existing installations, doubling the cross-section of the GND line is often sufficient to eliminate the potential difference. If the current flow on the GND line results in a voltage drop too high, this potential difference also affects the tree communication. This information can be found in the technical data of the light source. In the settings of the Smart TW actuator, the color temperature of the light source is set for warm white and cool white: The assignment of the connections is as follows: Two Smart TW actuators or one Smart TW actuator and two individual channels can be configured. Smart Tunable White actuators are supported by the Lighting Control block. Two outputs of the dimmer for cool white (CW) and warm white (WW) are combined per actuator. The color temperature can be adjusted from warm white to cool white by mixing the two colors.įor this purpose, Loxone Devices with RGBW Dimming outputs support the actuator type Smart Tunable White: Tunable White (TW) refers to lighting with white light that is adjustable in color temperature.įor this purpose, light sources such as LED strips are available that combine warm white light and cool white light. Output 1 - terminal red, output 2 - terminal green, output 3 - terminal blue, output 4 - terminal white If "Individual channels " is selected as actuator type in the properties of the device, the channel assignment is as follows: Shortly after power-up, the status LED will blink orange if the wiring is correct (connection to Tree Extension and Miniserver is established). I … current, L … cable length, A … wire cross-section, ΔU … voltage drop, ρ … resistance, ρ= constant (0,0172 for copper)Ĭonnect the power supply and Tree communication wires. This can be determined using the following formula: The wire size should be selected so that the voltage drop is not more than 1 V. The cable should be kept as short as possible to reduce voltage drop. The Compact Dimmer can be used without a separate enclosure. The RGBW Dimmers is installed on a DIN rail in a suitable enclosure. The functions are identical.ĭatasheet RGBW 24V Compact Dimmer Tree Table of Contents The device is also available in a compact housing (RGBW Compact Dimmer Tree). The 4 outputs can be configured as one RGBW channel, or can be used as 4 separate channels. With the RGBW Dimmer Tree, low-voltage LED spots and LED strips can be dimmed using PWM and any color moods can be mixed.
0 Comments
Leave a Reply. |